En

Centrifugal Fan Dimensions: All You Need to Know

Friday, 16 October 2026
Centrifugal Fan Dimensions

Choosing a centrifugal fan means specifying a unit that must fit into a specific installation, physically, aerodynamically and structurally. Centrifugal fan dimensions are never a matter of picking a size off a chart: across CBI’s centrifugal range, impeller diameters run from 280 mm to 2,450 mm in the standard series, and well beyond on custom-engineered projects, and every value in between answers a specific requirement. This guide explains what drives dimensional choices, how standard catalogue ranges suit different applications, and where custom engineering picks up when the catalogue ends.

 

 

What Determines Centrifugal Fan Dimensions: Key Parameters

Impeller diameter is the main size driver: casing and inlet are sized around it; the motor depends on the power and speed the application requires. Casing geometry, footprint and inlet configuration then follow from flow rate, pressure, fluid and temperature, within the limits of the installation. 

 

  • Impeller diameter and speed: at the same speed, flow rate grows with the cube of the diameter and pressure with its square, so a smaller impeller can reach the same pressure by turning faster;
  • Blade geometry: the fluid decides the blade, and the blade decides how much performance a given diameter can deliver;
  • Inlet configuration: a double-inlet impeller draws air from both sides and moves more flow than a single-inlet one of the same diameter;
  • Drive arrangement: direct coupling keeps the footprint compact and ties the fan to motor speed, while belt drive adds a transmission but lets the fan speed be set through the drive ratio;
  • Installation constraints: rotation direction, outlet orientation and duct connections determine how much space the installed fan actually takes up.

 

Contact us for more information

Compact and Standard-range Centrifugal Fans

For installations where flow and pressure requirements fall within standard parameters, CBI’s catalogue covers a broad dimensional span with four series. Two are compact and direct-driven, K and N; the other two, Ch and Z, scale up to impellers of nearly 2.5 metres while remaining within standard catalogue configurations.

Best applications

Large and Heavy-Duty Dimensional Configurations

When process requirements scale up, in pressure, flow, temperature or fluid aggressiveness, so does the engineering. At CBI, Heavy Duty is a construction approach, not a series: robust structures designed for intensive production in conditions of extreme temperature, dust and corrosive agents. The S, M and X series are designed for heavy-duty applications; the K series brings sturdy construction to air and gases loaded with dust, granular material and long fibres.

Best applications

Out-of-standard Dimensions: Custom Engineering

Standard catalogue sizes cover a wide range, but not every installation. Space constraints, non-standard pressure/flow combinations, or retrofit into existing ductwork all require a fan designed from scratch. CBI’s engineering process starts where the catalogue ends.

 

CFD modelling generates virtual prototypes, FEM analysis covers the structure, and testing rooms verify aeraulic performance.

 

When the fan is already in place, the Spares & Service Division handles revamping on site or at CBI facilities, on CBI and third-party fans, to optimise performance and extend service life. The starting point is a direct conversation with a CBI expert, around the duty point and the space the fan has to fit into.

 

Contact sent successfully!

Error sending contact! Try again!